Plastic Moulds for Concrete Test Cylinders

    2 1

After 2 years of testing and development, Hylec can now offer plastic moulds for casting concrete test cylinders as an alternative to conventional steel moulds.

An advantage of these moulds is that they weigh less than 1.5 kg each compared to 4.5 kg for a steel mould.  Either 2 or 4 samples can be safely carried by test personnel. Also the cleaning of these moulds using an organic acid spray and cloth takes less than half the time required for steel moulds.

The moulds are supplied with a detachable carry handle.

The moulds are also stackable with interlocking cap and base.

These moulds suit 100mm diameter test cylinders and have rigid 20mm thick sides and base. They also include a stainless steel base insert flat to 20 microns to prevent damage from rodding. Mould diameter is between 99.8mm and 100mm, which is more accurate than alternatives.

The base includes an outer steel plate to enable the mould to be used with a mechanical vibrator with magnetic clamping. This base has a laser cut serial number for mould identification.

The base has a 5mm diameter central hole with a plug held in place with a spring clip. This hole is used to eject the sample using an air supply of pressure of about 1-2 bar.

In operation the mould inner surfaces are coated with oil prior to casting of the sample to ensure easy removal of the sample by applying air pressure to the hole in the base.  Water can also be used for sample ejection.

A rigid plastic detachable lid prevents the sample from drying out as required by the standard. The lid and mould, being plastic, insulate the sample against the effects of hot and cold weather.

Tests show sample strength using plastic moulds is stronger at 3 and 10 days but with no detectable difference at 28 days.

The life of these plastic moulds has been found to be more than 5 years under the severe conditions found in the Middle East.

On October 29th, 2018, posted in: Featured Products, Latest News by

Leave a Reply